VOLVO Serial Diagnostic Cable

Volvo Vehicle OBD Diagnostic Cable RS232 to OBD II V70, 900 series, S90 and V90

Volvo OBD2 Scan Features:

New Design 232 Chipset based design
Works excellently volvo fault code reader 1.3 serial
version Serial port design, supports the most chanllenging time-critical application like
serial EEPROM programming

Supported Software:

OnBoardDiagnostics Versions: 1.3

Volvo FCR Communication Interfaces to connect a Volvo Vehicle to a PC

What can this interface be used for?

This interface (adapter) is used as an interface and an Serial cable to connect a volvo

vehicle to a PC for on-board diagnostics (OBD). It is fully compatible with the diagnostic

software version 1.3 from Volvo FCR. Volvo FCR is a software program that turns your PC into

a sophisticated Volvo diagnostic tool.

Product Features and Benifits:

-Supports Volvo FCR version 1.3 or older

-Precision-molded diagnostic connector made to fit all volvo vehicles, even those with

"tight" trim around diagnostic socket

-LED light indicating communication status

-High quality UL certified Serial Cables (equivalent to CE)

-Built-in, Electronic Protection from the "Aftermarket Radio Problem"

What is Volvo FCR?

Volvo FCR is a Windows-based Diagnostic Software for Volvo that emulates the

functions of the dealers' very expensive proprietary scan tools. As the first aftermarket

Volvo-Tool, it has the following features:

Volvo control module coverage includes:

-Engine - Petrol and Diesel

-ABS

-Automatic transmission

-SRS - airbag and other protection systems

-Driver and passenger seat memories

-Instruments, including service light reset

-Climate control - air conditioning

-Immobilizer

-Alarm

-Road traffic information

-Additional heater

How to Use?

-For laptops and PCs, download the shareware 1.3

-Run it and follow the prompts to allow it to install itself.

Note: You must install volvo FCR on your PC's hard disk -- it will not work properly

if you try running it directly from a floppy or CD. However, you can use a floppy or CD to

move the distribution file from a PC with internet access to another PC that does not have

internet access.

-Connect the interface between the computer and the car by plugging one end of the

interface into a Serial (RS232) (or USB port ) on your PC and the other end directly into

the OBD-II port present  passenger vehicles.

-Turn the car's ignition switch ON. No need to start the engine.

-Start the Volvo  program,

-Now it works. Make sure the software can reliably access all the control modules